Excimer

Category: Surface treatment & finishing lines

Booth No: L33

Characteristic

Excimer At a wavelength of 172 nm, Excimer lamps have an enormously highenergy emission that starts a polymerization process in the uppermost
part of a layer of UV-curable coating. The penetration depth of the UV
emission is comparatively low, so that this process leaves a thin film on
the wet coating without affecting the deeper layers of coating. Since this film formation is subject to shrinkage, the near-surface film has microfolds, resulting in
a matte surface. These can be cured during final curing
using conventional LAMPcure technology. The result is a mechanically
and chemically highly resistant and deep matt surface.